74ACT175PC

74ACT175PC Overview

16-DIP (0.300, 7.62mm)is the way it is packaged. You can find it in the Tubepackage. Differentialis the output configured for it. In the configuration of the trigger, Positive Edgeis used. Through Holemounts this electrical part. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. The operating temperature is -40°C~85°C TA. A flip flop of this type is classified as a D-Type. In FPGA terms, D flip flop is a type of 74ACTseries FPGA. It should not exceed 236MHzin terms of its output frequency. In total, there are 1 elements. Despite external influences, it consumes 40μAof quiescent current. D latch belongs to the 74ACT175 family. Its input capacitance is 4.5pFfarads. Electronic part Through Holeis mounted in the way. Basically, it is designed with a set of 16 pins. The clock edge trigger type for this device is Positive Edge. It is designed with 4bits. Despite its superior flexibility, it relies on 4 circuits to achieve it. If high efficiency is desired, the supply voltage should be kept at 5V. There are 2 output lines on it. This input has 1lines in it. In this case, the high level output current is set to -24mA. It is set to 24mAfor low level output current. Ideally, the operating temperature should be below 85°C. In order for the system to operate properly, the temperature should be higher than -40°C. It operates with the minimal supply voltage of 4.5V. The maximum supply voltage supported by the flip flop is 5.5V. This can be achieved at a frequency of 236MHz.

74ACT175PC Features

Tube package
74ACT series
16 pins
4 Bits

74ACT175PC Applications

There are a lot of ON Semiconductor 74ACT175PC Flip Flops applications.

• Frequency Divider circuits
• Bus hold
• Individual Asynchronous Resets
• QML qualified product
• Matched Rise and Fall
• Frequency division
• Guaranteed simultaneous switching noise level
• Shift registers
• Frequency Dividers
• Parallel data storage