74ACT273SC

74ACT273SC Overview

In the form of 20-SOIC (0.295, 7.50mm Width), it has been packaged. The Tubepackage contains it. T flip flop uses Non-Invertedas the output. JK flip flop uses Positive Edgeas the trigger. There is an electrical part that is mounted in the way of Surface Mount. The JK flip flop operates at a voltage of 4.5V~5.5V. -40°C~85°C TAis the operating temperature. It belongs to the type D-Typeof flip flops. FPGAs belonging to the 74ACTseries contain this type of chip. There should be no greater frequency than 189MHzon its output. There are 1 elements in it. T flip flop consumes 40μA quiescent energy. The 74ACT273 family contains this object. Its input capacitance is 4.5pFfarads. In this case, the electronic component is mounted in the way of Surface Mount. The 20pins are designed into the board. The clock edge trigger type for this device is Positive Edge. An electronic part with 8bits has been designed. The superior flexibility is achieved through the use of 8 circuits. High efficiency requires the supply voltage to be maintained at 5V. In order to operate, the chip has 8 output lines. A total of 3input lines have been provided. The high level output current is set to -24mA. There is no low level output current set at 24mA. It is recommended that the operating temperature be lower than 85°C. In order for the system to operate properly, the temperature should be higher than -40°C. The minimum voltage required for operation is 4.5V. A maximum voltage of 5.5V can be provided by it. A frequency of 189MHzcan be achieved.

74ACT273SC Features

Tube package
74ACT series
20 pins
8 Bits

74ACT273SC Applications

There are a lot of ON Semiconductor 74ACT273SC Flip Flops applications.

• CMOS Process
• Differential Individual
• Power down protection
• Divide a clock signal by 2 or 4
• Data storage
• Automotive
• High Performance Logic for test systems
• ESD protection
• Shift Registers
• Common Clocks