74ACT374SCX

74ACT374SCX Overview

It is embeded in 20-SOIC (0.295, 7.50mm Width) case. You can find it in the Tape & Reel (TR)package. As configured, the output uses Tri-State, Non-Inverted. This trigger uses the value Positive Edge. There is an electric part mounted in the way of Surface Mount. It operates with a supply voltage of 4.5V~5.5V. A temperature of -40°C~85°C TAis considered to be the operating temperature. This electronic flip flop is of type D-Type. In terms of FPGAs, it belongs to the 74ACT series. You should not exceed 160MHzin the output frequency of the device. In total, there are 1 elements. As a result, it consumes 40μA quiescent current and is not affected by external forces. This D latch belongs to the family of 74ACT374. There is 4.5pF input capacitance for this T flip flop. Surface Mount mounts this electronic component. There are 20pins on it. It has a clock edge trigger type of Positive Edge. There are 8bits in its design. Its flexibility is enhanced by 8 circuits. The supply voltage should be maintained at 5V for high efficiency. The JK flip flop is with 3 output lines to operate. It is reported that there are 1 input lines. -24mAis set as the high level output current. In the low level output current setting, 24mAis used. If the operating temperature is lower than 85°C, it is recommended. The operating temperature should be higher than -40°C. It is powered by 4.5V as its minimum supply voltage. 5.5Vis its maximum supply voltage. The frequency that can be achieved is 90MHz.

74ACT374SCX Features

Tape & Reel (TR) package
74ACT series
20 pins
8 Bits

74ACT374SCX Applications

There are a lot of ON Semiconductor 74ACT374SCX Flip Flops applications.

• Single Down Count-Control Line
• ESCC
• Memory
• Automotive
• Functionally equivalent to the MC10/100EL29
• Test & Measurement
• Shift registers
• Balanced 24 mA output drivers
• Latch
• QML qualified product