74ACT374SJ

74ACT374SJ Overview

The flip flop is packaged in a case of 20-SOIC (0.209, 5.30mm Width). As part of the package Tube, it is embedded. As configured, the output uses Tri-State, Non-Inverted. It is configured with the trigger Positive Edge. It is mounted in the way of Surface Mount. The JK flip flop operates at 4.5V~5.5Vvolts. A temperature of -40°C~85°C TAis used in the operation. It belongs to the type D-Typeof flip flops. The 74ACTseries comprises this type of FPGA. There should be no greater frequency than 160MHzon its output. A total of 1elements are contained within it. During its operation, it consumes 40μA quiescent energy. The object belongs to the 74ACT374 family. Its input capacitance is 4.5pFfarads. In this case, the electronic component is mounted in the way of Surface Mount. 20pins are included in its design. There is a clock edge trigger type of Positive Edgeon this device. This flip flop is designed with 8 Bits. 8 circuits are used to achieve its superior flexibility. For high efficiency, the supply voltage should be set to 5V. There are 3 output lines in this JK flip flop. As of now, there are 1input lines. The high level output current is set to -24mA. It is set to 24mAfor the low level output current. It is recommended that the operating temperature be lower than 85°C. A temperature above -40°Cshould be used for the operation. A minimum supply voltage of 4.5V is required for these RS flip flops to operate. 5.5Vis its maximum supply voltage. The frequency that can be achieved is 160MHz.

74ACT374SJ Features

Tube package
74ACT series
20 pins
8 Bits

74ACT374SJ Applications

There are a lot of ON Semiconductor 74ACT374SJ Flip Flops applications.

• Bounce elimination switch
• Computing
• Differential Individual
• Reduced system switching noise
• Clock pulse
• Functionally equivalent to the MC10/100EL29
• Load Control
• Computers
• 2 – Bit synchronous counter
• Data Synchronizers