74ACT374SJX

74ACT374SJX Overview

It is packaged in the way of 20-SOIC (0.209, 5.30mm Width). Package Tape & Reel (TR)embeds it. As configured, the output uses Tri-State, Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. There is an electronic component mounted in the way of Surface Mount. The JK flip flop operates at 4.5V~5.5Vvolts. In the operating environment, the temperature is -40°C~85°C TA. D-Typedescribes this flip flop. FPGAs belonging to the 74ACTseries contain this type of chip. It should not exceed 160MHzin terms of its output frequency. A total of 1elements are contained within it. There is 40μA quiescent consumption. Members of the 74ACT374family make up this object. Its input capacitance is 4.5pFfarads. In this case, the electronic component is mounted in the way of Surface Mount. This board has 20 pins. There is a clock edge trigger type of Positive Edgeon this device. An electronic part with 8bits has been designed. 8 circuits are used to achieve its superior flexibility. The supply voltage should be maintained at 5V for high efficiency. There are no output lines on the JK flip flop. 1input lines are available for you to choose from. A high level output current of -24mAis set. 24mAis set as the low level output current. Ideally, the operating temperature should be below 85°C. Ideally, the operating temperature should be greater than -40°C. The minimal supply voltage is 4.5V. 5.5Vis the maximum supply voltage it supports. The frequency can be set to 160MHz.

74ACT374SJX Features

Tape & Reel (TR) package
74ACT series
20 pins
8 Bits

74ACT374SJX Applications

There are a lot of ON Semiconductor 74ACT374SJX Flip Flops applications.

• Latch-up performance
• Asynchronous counter
• Differential Individual
• Balanced 24 mA output drivers
• Bus hold
• Buffer registers
• Load Control
• Modulo – n – counter
• QML qualified product
• Communications