74ACT377MTC

74ACT377MTC Overview

It is embeded in 20-TSSOP (0.173, 4.40mm Width) case. The Tubepackage contains it. In the configuration, Non-Invertedis used as the output. It is configured with a trigger that uses a value of Positive Edge. Surface Mountis in the way of this electric part. A voltage of 4.5V~5.5Vis used as the supply voltage. Currently, the operating temperature is -40°C~85°C TA. It is an electronic flip flop with the type D-Type. It belongs to the 74ACTseries of FPGAs. This D flip flop should not have a frequency greater than 175MHz. D latch consists of 1 elements. There is a consumption of 40μAof quiescent energy. It is a member of the 74ACT377 family. This T flip flop has a capacitance of 4.5pF farads at the input. There is an electronic part that is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 20. This device has Positive Edgeas its clock edge trigger type. It is designed with a number of bits of 8. The superior flexibility of this circuit is achieved by using 8 circuits. If high efficiency is desired, the supply voltage should be kept at 5V. There are 8 output lines on it. Currently, there are 8 lines of input. It is set to -24mAfor the high level output current. A 24mAvalue is set for low-level output current. The operating temperature should be lower than 85°C. Ideally, the operating temperature should be greater than -40°C. The minimum voltage required for operation is 4.5V. The maximum supply voltage supported by the flip flop is 5.5V. This frequency can be achieved 175MHz.

74ACT377MTC Features

Tube package
74ACT series
20 pins
8 Bits

74ACT377MTC Applications

There are a lot of ON Semiconductor 74ACT377MTC Flip Flops applications.

• Synchronous counter
• Power down protection
• Data transfer
• Frequency Divider circuits
• Shift registers
• Parallel data storage
• Count Modes
• ESCC
• Automotive
• Supports Live Insertion