74ACT377SJ

74ACT377SJ Overview

20-SOIC (0.209, 5.30mm Width)is the way it is packaged. It is included in the package Tube. Non-Invertedis the output configured for it. There is a trigger configured with Positive Edge. Surface Mountis in the way of this electric part. A voltage of 4.5V~5.5Vis required for its operation. It is operating at a temperature of -40°C~85°C TA. The type of this D latch is D-Type. In terms of FPGAs, it belongs to the 74ACT series. This D flip flop should not have a frequency greater than 175MHz. The element count is 1 . It consumes 40μA of quiescent The 74ACT377 family contains this object. Its input capacitance is 4.5pFfarads. Electronic part Surface Mountis mounted in the way. Basically, it is designed with a set of 20 pins. This device exhibits a clock edge trigger type of Positive Edge. 8bits are used in its design. Despite its superior flexibility, it relies on 8 circuits to achieve it. If high efficiency is desired, the supply voltage should be kept at 5V. In order to operate, the chip has 8 output lines. 8input lines are available for you to choose from. It is set to -24mAfor the high level output current. Low level output current is set to 24mA. It is recommended that the operating temperature be lower than 85°C. Operating temperatures should be above -40°C. The RS flip flop is designed to operate with a minimal supply voltage of 4.5VV. 5.5Vis the maximum supply voltage supported by it. A frequency of 175MHzcan be achieved.

74ACT377SJ Features

Tube package
74ACT series
20 pins
8 Bits

74ACT377SJ Applications

There are a lot of ON Semiconductor 74ACT377SJ Flip Flops applications.

• Memory
• Power down protection
• Counters
• QML qualified product
• Reduced system switching noise
• Pattern generators
• Guaranteed simultaneous switching noise level
• Computing
• Matched Rise and Fall
• Shift Registers