74ACT377SJX

74ACT377SJX Overview

In the form of 20-SOIC (0.209, 5.30mm Width), it has been packaged. You can find it in the Tape & Reel (TR)package. This output is configured with Non-Inverted. JK flip flop uses Positive Edgeas the trigger. Surface Mountis in the way of this electric part. Powered by a 4.5V~5.5Vvolt supply, it operates as follows. It is at -40°C~85°C TAdegrees Celsius that the system is operating. This electronic flip flop is of type D-Type. It is a type of FPGA belonging to the 74ACT series. You should not exceed 175MHzin the output frequency of the device. In total, it contains 1 elements. As a result, it consumes 40μA quiescent current. It is a member of the 74ACT377 family. The input capacitance of this JK flip flopis 4.5pF farads. It is mounted by the way of Surface Mount. The 20pins are designed into the board. This device has the clock edge trigger type of Positive Edge. An electronic part with 8bits has been designed. Its superior flexibility is attributed to its use of 8 circuits. In order to ensure high efficiency, the supply voltage should remain at 5V. It has 8 output lines to operate. This input has 8lines in it. The high level output current is set to -24mA. 24mA is the low level output current. A temperature below 85°Cshould be used for operation. It is recommended that the operating temperature is higher than -40°C. It is powered by 4.5V as its minimum supply voltage. 5.5Vis its maximum supply voltage. 175MHzis the maximum frequency that can be achieved.

74ACT377SJX Features

Tape & Reel (TR) package
74ACT series
20 pins
8 Bits

74ACT377SJX Applications

There are a lot of ON Semiconductor 74ACT377SJX Flip Flops applications.

• ESD performance
• Instrumentation
• Control circuits
• Automotive
• Guaranteed simultaneous switching noise level
• Computing
• Pattern generators
• Memory
• High Performance Logic for test systems
• Consumer