74ACT534SCX

74ACT534SCX Overview

20-SOIC (0.295, 7.50mm Width)is the packaging method. It is contained within the Tape & Reel (TR)package. T flip flop is configured with an output of Tri-State, Inverted. It is configured with a trigger that uses a value of Positive Edge. There is an electronic component mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis required for its operation. Temperature is set to -40°C~85°C TA. It belongs to the type D-Typeof flip flops. In terms of FPGAs, it belongs to the 74ACT series. A frequency of 100MHzshould not be exceeded by its output. A total of 1elements are contained within it. T flip flop consumes 40μA quiescent energy. If you search by 74ACT534, you will find similar parts. This JK flip flop has a 4.5pFfarad input capacitance. There is an electronic part mounted in the way of Surface Mount. A total of 20pins are provided on this board. This device has Positive Edgeas its clock edge trigger type. 8bits are used in its design. Its flexibility is enhanced by 8 circuits. For high efficiency, the supply voltage should be set to 5V. In order to operate, the chip has 3 output lines. The number of input lines is 8. The high level output current is set to -24mA. 24mAis set as the low level output current. There should be a temperature below 85°Cduring operation. In order for the system to operate properly, the temperature should be higher than -40°C. The system operates with a minimum supply voltage of 4.5V. The maximum supply voltage supported by the flip flop is 5.5V. It is possible to achieve 100MHz frequencies.

74ACT534SCX Features

Tape & Reel (TR) package
74ACT series
20 pins
8 Bits

74ACT534SCX Applications

There are a lot of ON Semiconductor 74ACT534SCX Flip Flops applications.

• Circuit Design
• Communications
• Reduced system switching noise
• Frequency division
• Digital electronics systems
• Buffered Clock
• Modulo – n – counter
• Synchronous counter
• ESCC
• Supports Live Insertion