74ACT574SC

74ACT574SC Overview

It is embeded in 20-SOIC (0.295, 7.50mm Width) case. It is contained within the Tubepackage. T flip flop is configured with an output of Tri-State, Non-Inverted. It is configured with a trigger that uses Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. A temperature of -40°C~85°C TAis used in the operation. This D latch has the type D-Type. In terms of FPGAs, it belongs to the 74ACT series. It should not exceed 110MHzin its output frequency. The list contains 1 elements. This process consumes 40μA quiescents. It is a member of the 74ACT574 family. Its input capacitance is 4.5pFfarads. It is mounted in the way of Surface Mount. As you can see from the design, it has pins with 20. In this device, the clock edge trigger type is Positive Edge. It is designed with a number of bits of 8. 8 circuits are used to achieve its superior flexibility. High efficiency requires the supply voltage to be maintained at 5V. The output current of 24mA makes it feature maximum design flexibility. It operates with 3 output lines. 8input lines are available for you to choose from. -24mA is set as the high level output current. There is 24mA output current at the low level. It is recommended that the operating temperature be below 85°C. A temperature above -40°Cshould be used for the operation. The minimal supply voltage is 4.5V. It is capable of supporting a maximum supply voltage of 5.5V. It is possible to obtain a frequency of 110MHz. There are 8 gates in its basic building block. D flip flop includes 1 inpits.

74ACT574SC Features

Tube package
74ACT series
20 pins
8 Bits
8 gates

74ACT574SC Applications

There are a lot of ON Semiconductor 74ACT574SC Flip Flops applications.

• Divide a clock signal by 2 or 4
• Circuit Design
• Event Detectors
• Buffered Clock
• Bounce elimination switch
• Buffer registers
• Balanced Propagation Delays
• EMI reduction circuitry
• Reduced system switching noise
• Clock pulse