74ACT74MTCX

74ACT74MTCX Overview

The flip flop is packaged in a case of 14-TSSOP (0.173, 4.40mm Width). There is an embedded version in the package Tape & Reel (TR). T flip flop uses Differentialas the output. In the configuration of the trigger, Positive Edgeis used. Surface Mountis in the way of this electric part. It operates with a supply voltage of 4.5V~5.5V. In the operating environment, the temperature is -40°C~85°C TA. This electronic flip flop is of type D-Type. JK flip flop is a part of the 74ACTseries of FPGAs. It should not exceed 210MHzin its output frequency. A total of 2 elements are present. There is 20μA quiescent consumption. The 74ACT74 family contains it. This JK flip flop has a 4.5pFfarad input capacitance. There is an electronic component mounted in the way of Surface Mount. As you can see from the design, it has pins with 14. Its clock edge trigger type is Positive Edge. It is designed with a number of bits of 2. Its flexibility is enhanced by 2 circuits. If high efficiency is desired, the supply voltage should be kept at 5V. There are 1 output lines in this JK flip flop. Currently, there are 1 input lines present. It is set to -24mAfor the high level output current. A 24mAvalue is set for low-level output current. Operating temperatures should be lower than 85°C. In order for the system to operate properly, the temperature should be higher than -40°C. The minimum voltage required for operation is 4.5V. It is capable of supporting a maximum supply voltage of 5.5V. It is possible to achieve a frequency of 210MHz.

74ACT74MTCX Features

Tape & Reel (TR) package
74ACT series
14 pins
2 Bits

74ACT74MTCX Applications

There are a lot of ON Semiconductor 74ACT74MTCX Flip Flops applications.

• Buffer registers
• Consumer
• Frequency Divider circuits
• Safety Clamp
• Balanced Propagation Delays
• Matched Rise and Fall
• Memory
• Bounce elimination switch
• Communications
• Parallel data storage