74ACTQ16374MTDX

74ACTQ16374MTDX Overview

The flip flop is packaged in 48-TFSOP (0.240, 6.10mm Width). A package named Tape & Reel (TR)includes it. In the configuration, Tri-State, Non-Invertedis used as the output. In the configuration of the trigger, Positive Edgeis used. The electronic part is mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. The operating temperature is -40°C~85°C TA. This electronic flip flop is of type D-Type. In this case, it is a type of FPGA belonging to the 74ACTQ series. A frequency of 71MHzshould be the maximum output frequency. A total of 2elements are present in it. There is 80μA quiescent consumption. The 74ACTQ16374family includes it. This T flip flop has a capacitance of 4.5pF farads at the input. It is mounted in the way of Surface Mount. Basically, it is designed with a set of 48 pins. This device exhibits a clock edge trigger type of Positive Edge. It is designed with a number of bits of 16. The superior flexibility of this circuit is achieved by using 16 circuits. For high efficiency, the supply voltage should be kept at 5V. It has 3 output lines to operate. It is reported that there are 8 input lines. -24mAis the output current at high level. In the low level output current setting, the current is set to 24mA. Ideally, the operating temperature should be lower than 85°C. It is recommended that the operating temperature is higher than -40°C. It is powered by 4.5V as its minimum supply voltage. It supports a maximum supply voltage of 5.5V volts. A frequency of 71MHzcan be achieved.

74ACTQ16374MTDX Features

Tape & Reel (TR) package
74ACTQ series
48 pins
16 Bits

74ACTQ16374MTDX Applications

There are a lot of ON Semiconductor 74ACTQ16374MTDX Flip Flops applications.

• Patented noise
• ATE
• Data transfer
• Circuit Design
• Event Detectors
• Memory
• Automotive
• Data Synchronizers
• EMI reduction circuitry
• Single Up Count-Control Line