74ACTQ18823MTD

74ACTQ18823MTD Overview

56-TFSOP (0.240, 6.10mm Width)is the packaging method. There is an embedded version in the package Tube. Tri-State, Non-Invertedis the output configured for it. In the configuration of the trigger, Positive Edgeis used. This electronic part is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. A temperature of -40°C~85°C TAis considered to be the operating temperature. A flip flop of this type is classified as a D-Type. In FPGA terms, D flip flop is a type of 74ACTQseries FPGA. A frequency of 100MHzshould be the maximum output frequency. There are 2 elements in it. There is 80μA quiescent consumption. The object belongs to the 74ACTQ18823 family. This JK flip flop has a 4.5pFfarad input capacitance. It is mounted by the way of Surface Mount. 56pins are included in its design. It has a clock edge trigger type of Positive Edge. An electronic part with 18bits has been designed. The superior flexibility is achieved through the use of 18 circuits. For high efficiency, the supply voltage should be kept at 5V. There are 3 output lines in this JK flip flop. A total of 9input lines have been provided. The high level output current is set to -24mA. 24mAis set as the low level output current. It is recommended that the operating temperature be below 85°C. Temperatures above -40°Cshould be used. The RS flip flop is designed to operate with a minimal supply voltage of 4.5VV. It supports the maximal supply voltage of 5.5V. The frequency that can be achieved is 100MHz.

74ACTQ18823MTD Features

Tube package
74ACTQ series
56 pins
18 Bits

74ACTQ18823MTD Applications

There are a lot of ON Semiconductor 74ACTQ18823MTD Flip Flops applications.

• Asynchronous counter
• Differential Individual
• Computing
• Cold spare funcion
• Modulo – n – counter
• Balanced 24 mA output drivers
• Test & Measurement
• Guaranteed simultaneous switching noise level
• Count Modes
• Bounce elimination switch