74ALVC162374TX

74ALVC162374TX Overview

In the form of 48-TFSOP (0.240, 6.10mm Width), it has been packaged. You can find it in the Tape & Reel (TR)package. The output it is configured with uses Tri-State, Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. There is an electronic component mounted in the way of Surface Mount. With a supply voltage of 1.65V~3.6V volts, it operates. Temperature is set to -40°C~85°C TA. This electronic flip flop is of type D-Type. In this case, it is a type of FPGA belonging to the 74ALVC series. This D flip flop should not have a frequency greater than 250MHz. In total, there are 2 elements. This process consumes 40μA quiescents. Members of the 74ALVC162374family make up this object. This JK flip flop has a 6pFfarad input capacitance. Electronic part Surface Mountis mounted in the way. This board has 48 pins. It has a clock edge trigger type of Positive Edge. The flip flop is designed with 16bits. Its flexibility is enhanced by 2 circuits. It is designed with 3 output lines. Currently, there are 8 input lines present. It is set to -6mAfor the high level output current. There is 6mA output current at the low level. Ideally, the operating temperature should be lower than 85°C. It should be higher than -40°Cwhen the system is operating. The RS flip flop is designed to operate with a minimal supply voltage of 1.65VV. 3.6Vis the maximum supply voltage it supports. This can be achieved at a frequency of 200MHz.

74ALVC162374TX Features

Tape & Reel (TR) package
74ALVC series
48 pins
16 Bits

74ALVC162374TX Applications

There are a lot of ON Semiconductor 74ALVC162374TX Flip Flops applications.

• Single Up Count-Control Line
• Asynchronous counter
• Matched Rise and Fall
• Cold spare funcion
• Modulo – n – counter
• Storage Registers
• Balanced Propagation Delays
• Latch-up performance
• Counters
• Test & Measurement