74F174SC

74F174SC Overview

The flip flop is packaged in 16-SOIC (0.154, 3.90mm Width). D flip flop is included in the Tubepackage. T flip flop is configured with an output of Non-Inverted. There is a trigger configured with Positive Edge. It is mounted in the way of Surface Mount. The JK flip flop operates at 4.5V~5.5Vvolts. A temperature of 0°C~70°C TAis used in the operation. A flip flop of this type is classified as a D-Type. In FPGA terms, D flip flop is a type of 74Fseries FPGA. It should not exceed 80MHzin terms of its output frequency. A total of 1elements are contained within it. This process consumes 45mA quiescents. The 74F174 family contains this object. It is mounted in the way of Surface Mount. It is designed with 16 pins. There is a clock edge trigger type of Positive Edgeon this device. This flip flop is designed with 6 Bits. Despite its superior flexibility, it relies on 7 circuits to achieve it. For high efficiency, the supply voltage should be set to 5V. It is designed with 3 output lines. There are 6 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply. The high level output current is set to -1mA. The low level output current is set to 20mA. If the operating temperature is lower than 70°C, it is recommended. The operating temperature should be higher than 0°C. The system operates with a minimum supply voltage of 4.5V. It supports a maximum supply voltage of 5.5V volts. It is possible to obtain a frequency of 80MHz.

74F174SC Features

Tube package
74F series
16 pins
6 Bits

74F174SC Applications

There are a lot of ON Semiconductor 74F174SC Flip Flops applications.

• Set-reset capability
• Shift Registers
• Buffer registers
• Latch-up performance
• Circuit Design
• EMI reduction circuitry
• Storage registers
• Computing
• Guaranteed simultaneous switching noise level
• Patented noise