74F174SJ

74F174SJ Overview

16-SOIC (0.209, 5.30mm Width)is the way it is packaged. The Tubepackage contains it. Currently, the output is configured to use Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. The JK flip flop operates at 4.5V~5.5Vvolts. Temperature is set to 0°C~70°C TA. D-Typedescribes this flip flop. JK flip flop is a part of the 74Fseries of FPGAs. You should not exceed 80MHzin its output frequency. A total of 1elements are contained within it. As a result, it consumes 45mA quiescent current. The object belongs to the 74F174 family. It is mounted in the way of Surface Mount. There are 16pins on it. There is a clock edge trigger type of Positive Edgeon this device. It is designed with 6bits. Despite its superior flexibility, it relies on 7 circuits to achieve it. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. There are 3 output lines on it. It has 6lines. -1mA is set as the high level output current. There is 20mA output current at the low level. If the operating temperature is lower than 70°C, it is recommended. It is recommended that the operating temperature is higher than 0°C. The minimum voltage required for operation is 4.5V. 5.5Vis the maximum supply voltage it supports. The frequency that can be achieved is 80MHz.

74F174SJ Features

Tube package
74F series
16 pins
6 Bits

74F174SJ Applications

There are a lot of ON Semiconductor 74F174SJ Flip Flops applications.

• Bounce elimination switch
• Reduced system switching noise
• Bus hold
• Supports Live Insertion
• Convert a momentary switch to a toggle switch
• Computers
• Shift Registers
• Computing
• Latch-up performance
• Storage Registers