74F174SJX

74F174SJX Overview

In the form of 16-SOIC (0.209, 5.30mm Width), it has been packaged. It is included in the package Tape & Reel (TR). T flip flop uses Non-Invertedas the output. In the configuration of the trigger, Positive Edgeis used. Surface Mountmounts this electrical part. With a supply voltage of 4.5V~5.5V volts, it operates. Currently, the operating temperature is 0°C~70°C TA. This D latch has the type D-Type. This type of FPGA is a part of the 74F series. There should be no greater frequency than 80MHzon its output. In total, there are 1 elements. There is a consumption of 45mAof quiescent energy. The 74F174 family contains this object. There is an electronic component mounted in the way of Surface Mount. 16pins are included in its design. This device's clock edge trigger type is Positive Edge. There are 6bits in this flip flop. Using 7 circuits, it is highly flexible. The supply voltage should be maintained at 5V for high efficiency. The JK flip flop is with 3 output lines to operate. A total of 6input lines have been provided. -1mAis the output current at high level. 20mA is the low level output current. A temperature below 70°Cshould be used for operation. It is recommended that the operating temperature is higher than 0°C. The minimal supply voltage is 4.5V. The maximum supply voltage supported by the flip flop is 5.5V. It is possible to achieve 80MHz frequencies.

74F174SJX Features

Tape & Reel (TR) package
74F series
16 pins
6 Bits

74F174SJX Applications

There are a lot of ON Semiconductor 74F174SJX Flip Flops applications.

• Memory
• Guaranteed simultaneous switching noise level
• 2 – Bit synchronous counter
• Individual Asynchronous Resets
• Data storage
• Computing
• Consumer
• Supports Live Insertion
• Set-reset capability
• Convert a momentary switch to a toggle switch