74F175SCX

74F175SCX Overview

The package is in the form of 16-SOIC (0.154, 3.90mm Width). D flip flop is embedded in the Tape & Reel (TR) package. T flip flop uses Differentialas the output. In the configuration of the trigger, Positive Edgeis used. Surface Mountis occupied by this electronic component. The JK flip flop operates at 4.5V~5.5Vvolts. In this case, the operating temperature is 0°C~70°C TA. D-Typedescribes this flip flop. The 74Fseries comprises this type of FPGA. You should not exceed 140MHzin the output frequency of the device. The list contains 1 elements. There is a consumption of 34mAof quiescent energy. It is a member of the 74F175 family. This electronic part is mounted in the way of Surface Mount. The 16pins are designed into the board. A Positive Edgeclock edge trigger is used in this device. Flip flops designed with 4bits are used in this part. In order to achieve its superior flexibility, 4 circuits are used. The supply voltage should be maintained at 5V for high efficiency. There are 3 output lines on it. A total of 4input lines have been provided. High level output current is set to -1mA. In the low level output current setting, the current is set to 20mA. Operating temperatures should be lower than 70°C. It is recommended that the operating temperature is higher than 0°C. A minimum supply voltage of 4.5V is required for these RS flip flops to operate. 5.5Vis its maximum supply voltage. A frequency of 140MHzcan be achieved.

74F175SCX Features

Tape & Reel (TR) package
74F series
16 pins
4 Bits

74F175SCX Applications

There are a lot of ON Semiconductor 74F175SCX Flip Flops applications.

• Pattern generators
• Latch-up performance
• Latch
• ATE
• Reduced system switching noise
• Matched Rise and Fall
• Frequency Divider circuits
• Single Down Count-Control Line
• Consumer
• Data storage