74F175SJ

74F175SJ Overview

The package is in the form of 16-SOIC (0.209, 5.30mm Width). It is included in the package Tube. T flip flop is configured with an output of Differential. This trigger uses the value Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis required for its operation. A temperature of 0°C~70°C TAis used in the operation. D-Typeis the type of this D latch. It is a type of FPGA belonging to the 74F series. A frequency of 140MHzshould not be exceeded by its output. A total of 1 elements are present. There is 34mA quiescent consumption. If you search by 74F175, you will find similar parts. Surface Mount mounts this electronic component. It is designed with 16 pins. This device exhibits a clock edge trigger type of Positive Edge. An electronic part designed with 4bits is used in this application. Its flexibility is enhanced by 4 circuits. For high efficiency, the supply voltage should be set to 5V. There are 3 output Lines, which generate the binary equivalent of the input line whose value is equal to “1” and are available to encode either a decimal or hexadecimal input pattern to typically a binary or “B. C. D” (binary coded decimal) output code. It is reported that there are 4 input lines. A -1mAvalue is set for the high level output current. A 20mAvalue is set for low-level output current. Ideally, the operating temperature should be lower than 70°C. It is recommended that the operating temperature is higher than 0°C. The minimum voltage required for operation is 4.5V. 5.5Vis the maximum supply voltage it supports. The frequency that can be achieved is 140MHz.

74F175SJ Features

Tube package
74F series
16 pins
4 Bits

74F175SJ Applications

There are a lot of ON Semiconductor 74F175SJ Flip Flops applications.

• Count Modes
• Load Control
• Frequency Dividers
• Counters
• EMI reduction circuitry
• Storage Registers
• Power down protection
• Data storage
• Consumer
• Patented noise