74F273SJ

74F273SJ Overview

The package is in the form of 20-SOIC (0.209, 5.30mm Width). D flip flop is included in the Tubepackage. Non-Invertedis the output configured for it. There is a trigger configured with Positive Edge. It is mounted in the way of Surface Mount. A 4.5V~5.5Vsupply voltage is required for it to operate. 0°C~70°C TAis the operating temperature. There is D-Type type of electronic flip flop associated with this device. In FPGA terms, D flip flop is a type of 74Fseries FPGA. You should not exceed 160MHzin its output frequency. The list contains 1 elements. As a result, it consumes 44mA of quiescent current without being affected by external factors. This D latch belongs to the family of 74F273. It is mounted in the way of Surface Mount. A total of 20pins are provided on this board. In this device, the clock edge trigger type is Positive Edge. The design is based on 8bits. The superior flexibility is achieved through the use of 8 circuits. In order to achieve high efficiency, the supply voltage should be maintained at 5V. To operate, the chip has a total of 3 output lines. This input has 8lines. High level output current is set to -1mA. 20mAis set as the low level output current. A temperature below 70°Cshould be used for operation. Operating temperatures should be above 0°C. In order for it to operate, a supply voltage of 4.5Vis required. There is a maximum supply voltage of 5.5V. This frequency can be achieved at 160MHz.

74F273SJ Features

Tube package
74F series
20 pins
8 Bits

74F273SJ Applications

There are a lot of ON Semiconductor 74F273SJ Flip Flops applications.

• ESD performance
• Memory
• Synchronous counter
• Buffer registers
• Storage registers
• Consumer
• ATE
• Matched Rise and Fall
• Circuit Design
• Single Up Count-Control Line