74F374PC

74F374PC Overview

The flip flop is packaged in a case of 20-DIP (0.300, 7.62mm). You can find it in the Tubepackage. This output is configured with Tri-State, Non-Inverted. In the configuration of the trigger, Positive Edgeis used. Through Holeis in the way of this electric part. A voltage of 4.5V~5.5Vis required for its operation. A temperature of 0°C~70°C TAis used in the operation. This D latch has the type D-Type. In terms of FPGAs, it belongs to the 74F series. This D flip flop should not have a frequency greater than 140MHz. In total, it contains 1 elements. As a result, it consumes 86mA quiescent current. Members of the 74F374family make up this object. There is an electronic part mounted in the way of Through Hole. This board has 20 pins. There is a clock edge trigger type of Positive Edgeon this device. There are 8bits in its design. Despite its superior flexibility, it relies on 8 circuits to achieve it. The supply voltage should be maintained at 5V for high efficiency. There are 3 output lines on it. The number of input lines is 8. -3mA is set as the high level output current. 24mAis set as the low level output current. A temperature below 70°Cshould be used for operation. A temperature above 0°Cshould be used for the operation. The RS flip flop is designed to operate with a minimal supply voltage of 4.5VV. A maximum voltage of 5.5V can be provided by it. The frequency can be set to 140MHz.

74F374PC Features

Tube package
74F series
20 pins
8 Bits

74F374PC Applications

There are a lot of ON Semiconductor 74F374PC Flip Flops applications.

• Parallel data storage
• Latch
• Circuit Design
• Data storage
• Latch-up performance
• Reduced system switching noise
• Pattern generators
• Computers
• Patented noise
• Shift registers