74F377PC

74F377PC Overview

The flip flop is packaged in a case of 20-DIP (0.300, 7.62mm). You can find it in the Tubepackage. As configured, the output uses Non-Inverted. The trigger it is configured with uses Positive Edge. Through Holeis occupied by this electronic component. Powered by a 4.5V~5.5Vvolt supply, it operates as follows. A temperature of 0°C~70°C TAis considered to be the operating temperature. D-Typeis the type of this D latch. It is a type of FPGA belonging to the 74F series. You should not exceed 130MHzin its output frequency. A total of 1elements are contained within it. During its operation, it consumes 48mA quiescent energy. The 74F377family includes it. It is mounted by the way of Through Hole. This board has 20 pins. It has a clock edge trigger type of Positive Edge. There are 8bits in its design. In order to achieve its superior flexibility, 1 circuits are used. The supply voltage should be maintained at 5V for high efficiency. To operate, the chip has a total of 3 output lines. This input has 8lines. -1mA is set as the high level output current. A 20mAvalue is set for low-level output current. There should be a temperature below 70°Cduring operation. It is recommended that the operating temperature is higher than 0°C. A minimum supply voltage of 4.5V is required for these RS flip flops to operate. 5.5Vis the maximum supply voltage supported by it. This can be achieved at a frequency of 130MHz.

74F377PC Features

Tube package
74F series
20 pins
8 Bits

74F377PC Applications

There are a lot of ON Semiconductor 74F377PC Flip Flops applications.

• ESD performance
• Event Detectors
• Frequency Dividers
• Cold spare funcion
• Synchronous counter
• Guaranteed simultaneous switching noise level
• Shift Registers
• Data transfer
• EMI reduction circuitry
• Count Modes