74F534SC

74F534SC Overview

The item is packaged in 20-SOIC (0.295, 7.50mm Width)cases. As part of the package Tube, it is embedded. As configured, the output uses Tri-State, Inverted. JK flip flop uses Positive Edgeas the trigger. This electronic part is mounted in the way of Surface Mount. A 4.5V~5.5Vsupply voltage is required for it to operate. It is at 0°C~70°C TAdegrees Celsius that the system is operating. It belongs to the type D-Typeof flip flops. In FPGA terms, D flip flop is a type of 74Fseries FPGA. This D flip flop should not have a frequency greater than 100MHz. A total of 1elements are contained within it. Despite external influences, it consumes 86mAof quiescent current. D latch belongs to the 74F534 family. It is mounted by the way of Surface Mount. As you can see from the design, it has pins with 20. The clock edge trigger type for this device is Positive Edge. It is designed with 8bits. Its superior flexibility is attributed to its use of 8 circuits. The supply voltage should be maintained at 5V for high efficiency. There are 8 output lines on it. As of now, there are 1input lines. -3mAis set as the high level output current. It is set to 24mAfor the low level output current. There should be a temperature below 70°Cduring operation. Ideally, the operating temperature should be higher than 0°C. The RS flip flop is designed to operate with a minimal supply voltage of 4.5VV. 5.5Vis its maximum supply voltage. We are able to achieve a frequency of 100MHz.

74F534SC Features

Tube package
74F series
20 pins
8 Bits

74F534SC Applications

There are a lot of ON Semiconductor 74F534SC Flip Flops applications.

• Data storage
• Dynamic threshold performance
• Latch
• Buffered Clock
• ATE
• Synchronous counter
• Computing
• QML qualified product
• Set-reset capability
• Buffer registers