74F534SJ

74F534SJ Overview

In the form of 20-SOIC (0.209, 5.30mm Width), it has been packaged. It is contained within the Tubepackage. T flip flop uses Tri-State, Invertedas the output. The trigger configured with it uses Positive Edge. This electronic part is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. In the operating environment, the temperature is 0°C~70°C TA. D-Typedescribes this flip flop. FPGAs belonging to the 74Fseries contain this type of chip. Its output frequency should not exceed 100MHz Hz. A total of 1elements are contained within it. It consumes 86mA of quiescent current without being affected by external factors. This D latch belongs to the family of 74F534. Surface Mount mounts this electronic component. The electronic flip flop is designed with pins 20. This device exhibits a clock edge trigger type of Positive Edge. The flip flop is designed with 8bits. The superior flexibility is achieved through the use of 8 circuits. In order to ensure high efficiency, the supply voltage should remain at 5V. It operates with 8 output lines. A total of 1input lines have been provided. A -3mAis set for the high level output current. The low level output current is set to 24mA. The operating temperature should be lower than 70°C. In order for the system to operate properly, the temperature should be higher than 0°C. Initially, it requires a voltage of 4.5V as the minimum supply voltage. There is a maximum voltage support of 5.5V. It is possible to achieve 100MHz frequencies.

74F534SJ Features

Tube package
74F series
20 pins
8 Bits

74F534SJ Applications

There are a lot of ON Semiconductor 74F534SJ Flip Flops applications.

• Data Synchronizers
• Count Modes
• Communications
• Single Up Count-Control Line
• ESCC
• Test & Measurement
• Pattern generators
• Shift registers
• Set-reset capability
• ATE