74F534SJX

74F534SJX Overview

It is embeded in 20-SOIC (0.209, 5.30mm Width) case. The Tape & Reel (TR)package contains it. In the configuration, Tri-State, Invertedis used as the output. JK flip flop uses Positive Edgeas the trigger. There is an electronic component mounted in the way of Surface Mount. With a supply voltage of 4.5V~5.5V volts, it operates. In this case, the operating temperature is 0°C~70°C TA. It belongs to the type D-Typeof flip flops. In this case, it is a type of FPGA belonging to the 74F series. In order for it to function properly, its output frequency should not exceed 100MHz. The element count is 1 . There is 86mA quiescent consumption. Members of the 74F534family make up this object. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 20pins on it. This device exhibits a clock edge trigger type of Positive Edge. This flip flop is designed with 8 Bits. The superior flexibility of this circuit is achieved by using 8 circuits. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. There are 8 output lines on it. This input has 1lines in it. -3mA is set as the high level output current. 24mAis set as the low level output current. A temperature below 70°Cshould be used for operation. Ideally, the operating temperature should be higher than 0°C. Initially, it requires a voltage of 4.5V as the minimum supply voltage. 5.5Vis its maximum supply voltage. This frequency can be achieved at 100MHz.

74F534SJX Features

Tape & Reel (TR) package
74F series
20 pins
8 Bits

74F534SJX Applications

There are a lot of ON Semiconductor 74F534SJX Flip Flops applications.

• Frequency Divider circuits
• Individual Asynchronous Resets
• EMI reduction circuitry
• Balanced 24 mA output drivers
• Safety Clamp
• Data Synchronizers
• Guaranteed simultaneous switching noise level
• Balanced Propagation Delays
• Single Down Count-Control Line
• Latch