74F564PC

74F564PC Overview

The flip flop is packaged in a case of 20-DIP (0.300, 7.62mm). There is an embedded version in the package Tube. This output is configured with Tri-State, Non-Inverted. The trigger it is configured with uses Positive Edge. Through Holeis occupied by this electronic component. Powered by a 4.5V~5.5Vvolt supply, it operates as follows. A temperature of 0°C~70°C TAis considered to be the operating temperature. This D latch has the type D-Type. It belongs to the 74Fseries of FPGAs. A frequency of 100MHzshould be the maximum output frequency. There are 1 elements in it. It consumes 86mA of quiescent You can search similar parts based on 74F564. A part of the electronic system is mounted in the way of Through Hole. A total of 20pins are provided on this board. There is a clock edge trigger type of Positive Edgeon this device. An electronic part with 8bits has been designed. Despite its superior flexibility, it relies on 8 circuits to achieve it. The supply voltage should be maintained at 5V for high efficiency. In order to operate, the chip has 8 output lines. There are 1 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply. It is set to -3mAfor the high level output current. The low level output current is set to 24mA. A temperature below 70°Cshould be used for operation. If the operating temperature is higher than 0°C, the system should operate properly. A minimum supply voltage of 4.5V is required for these RS flip flops to operate. 5.5Vis its maximum supply voltage. A frequency of 100MHzcan be achieved.

74F564PC Features

Tube package
74F series
20 pins
8 Bits

74F564PC Applications

There are a lot of ON Semiconductor 74F564PC Flip Flops applications.

• Bus hold
• Asynchronous counter
• Clock pulse
• Guaranteed simultaneous switching noise level
• Balanced Propagation Delays
• Data Synchronizers
• Load Control
• CMOS Process
• Automotive
• Divide a clock signal by 2 or 4