74F574PC

74F574PC Overview

In the form of 20-DIP (0.300, 7.62mm), it has been packaged. A package named Tubeincludes it. T flip flop uses Tri-State, Non-Invertedas its output configuration. This trigger uses the value Positive Edge. There is an electrical part that is mounted in the way of Through Hole. The JK flip flop operates at a voltage of 4.5V~5.5V. It is operating at 0°C~70°C TA. There is D-Type type of electronic flip flop associated with this device. In this case, it is a type of FPGA belonging to the 74F series. A frequency of 100MHzshould not be exceeded by its output. A total of 1elements are present in it. As a result, it consumes 86mA of quiescent current without being affected by external factors. If you search by 74F574, you will find similar parts. The electronic part is mounted in the way of Through Hole. The electronic flip flop is designed with pins 20. This device has Positive Edgeas its clock edge trigger type. This flip flop is designed with 8 Bits. Despite its superior flexibility, it relies on 8 circuits to achieve it. The supply voltage should be maintained at 5V for high efficiency. It offers maximum design flexibility with its output current of 24mA. It is designed with 3 output lines. Currently, there are 1 input lines present. High level output current is set to -3mA. There is no low level output current set at 24mA. Temperatures below 70°Care ideal for operating. A temperature above 0°Cshould be used for the operation. It operates with the minimal supply voltage of 4.5V. A maximum voltage of 5.5V can be provided by it. The frequency that can be achieved is 100MHz.

74F574PC Features

Tube package
74F series
20 pins
8 Bits

74F574PC Applications

There are a lot of ON Semiconductor 74F574PC Flip Flops applications.

• Shift registers
• Single Up Count-Control Line
• Computers
• Buffer registers
• Storage Registers
• Convert a momentary switch to a toggle switch
• Reduced system switching noise
• Data storage
• Common Clocks
• Single Down Count-Control Line