74F74SCX

74F74SCX Overview

The item is packaged in 14-SOIC (0.154, 3.90mm Width)cases. It is included in the package Tape & Reel (TR). T flip flop uses Differentialas the output. It is configured with a trigger that uses a value of Positive Edge. Surface Mountmounts this electrical part. A 4.5V~5.5Vsupply voltage is required for it to operate. In the operating environment, the temperature is 0°C~70°C TA. This logic flip flop is classified as type D-Type. The FPGA belongs to the 74F series. A frequency of 125MHzshould be the maximum output frequency. There are 2 elements in it. Despite external influences, it consumes 16mAof quiescent current. JK flip flop belongs to 74F74 family. The electronic part is mounted in the way of Surface Mount. This board is designed with 14pins on it. This device has the clock edge trigger type of Positive Edge. An electronic part with 2bits has been designed. The superior flexibility is achieved through the use of 2 circuits. High efficiency requires the supply voltage to be maintained at 5V. It has 2 output lines to operate. This input has 4lines. -1mAis set as the high level output current. There is no low level output current set at 20mA. The operating temperature should be lower than 70°C. Operating temperatures should be above 0°C. Normally, it operates with a voltage of 4.5VV as its minimum supply voltage. It supports a maximum supply voltage of 5.5V volts. It is possible to achieve 100MHz frequencies.

74F74SCX Features

Tape & Reel (TR) package
74F series
14 pins
2 Bits

74F74SCX Applications

There are a lot of ON Semiconductor 74F74SCX Flip Flops applications.

• Automotive
• Latch
• Matched Rise and Fall
• Communications
• Balanced 24 mA output drivers
• Divide a clock signal by 2 or 4
• EMI reduction circuitry
• Consumer
• Memory
• Computing