74F74SJ

74F74SJ Overview

In the form of 14-SOIC (0.209, 5.30mm Width), it has been packaged. Package Tubeembeds it. Differentialis the output configured for it. This trigger uses the value Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. A temperature of 0°C~70°C TAis used in the operation. D-Typedescribes this flip flop. This type of FPGA is a part of the 74F series. This D flip flop should not have a frequency greater than 125MHz. In total, it contains 2 elements. This process consumes 16mA quiescents. The 74F74 family contains it. There is an electronic part that is mounted in the way of Surface Mount. The 14pins are designed into the board. This device's clock edge trigger type is Positive Edge. There are 2bits in this flip flop. Despite its superior flexibility, it relies on 2 circuits to achieve it. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. It is designed with 2 output lines. Currently, there are 4 lines of input. -1mAis set as the high level output current. 20mAis set as the low level output current. If the operating temperature is lower than 70°C, it is recommended. It is recommended that the operating temperature is higher than 0°C. Initially, it requires a voltage of 4.5V as the minimum supply voltage. It is capable of supporting a maximum supply voltage of 5.5V. A frequency of 125MHzcan be achieved.

74F74SJ Features

Tube package
74F series
14 pins
2 Bits

74F74SJ Applications

There are a lot of ON Semiconductor 74F74SJ Flip Flops applications.

• QML qualified product
• Digital electronics systems
• Data storage
• Computers
• Shift Registers
• Circuit Design
• Single Up Count-Control Line
• Set-reset capability
• Reduced system switching noise
• Bounce elimination switch