74F794PC

74F794PC Overview

The package is in the form of 20-DIP (0.300, 7.62mm). It is contained within the Tubepackage. T flip flop is configured with an output of Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. Through Holeis positioned in the way of this electronic part. It operates with a supply voltage of 4.5V~5.5V. It is operating at 0°C~70°C TA. D-Typedescribes this flip flop. In FPGA terms, D flip flop is a type of 74Fseries FPGA. It should not exceed 90MHzin terms of its output frequency. There are 1 elements in it. There is a consumption of 65mAof quiescent energy. The 74F794 family contains this object. A part of the electronic system is mounted in the way of Through Hole. This board is designed with 20pins on it. A Positive Edgeclock edge trigger is used in this device. The flip flop is designed with 8bits. Its superior flexibility is attributed to its use of 8 circuits. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. To operate, the chip has a total of 2 output lines. Currently, there are 1 lines of input. A high level output current of -15mAis set. It is set to 64mAfor low level output current. Operating temperatures should be lower than 70°C. If the operating temperature is higher than 0°C, the system should operate properly. The system operates with a minimum supply voltage of 4.5V. It is capable of supporting a maximum supply voltage of 5.5V. We are able to achieve a frequency of 90MHz.

74F794PC Features

Tube package
74F series
20 pins
8 Bits

74F794PC Applications

There are a lot of ON Semiconductor 74F794PC Flip Flops applications.

• Control circuits
• Load Control
• CMOS Process
• Data transfer
• Counters
• 2 – Bit synchronous counter
• Data storage
• Frequency Divider circuits
• Patented noise
• Bounce elimination switch