74FCT162823CTPVG

74FCT162823CTPVG Overview

It is embeded in SSOP case. A total of 2 elements are present. There are 56 terminations,Power is supplied from a voltage of 5V volts. A device of this type belongs to the family of FCT. In this case, the electronic component is mounted in the way of Surface Mount. This board has 56 pins. This device exhibits a clock edge trigger type of Positive Edge. It is included in FF/Latches. This flip flop is designed with 18 Bits. The D latch runs on a voltage of 5V volts. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. As a result, it consumes 500μA of quiescent current without being affected by external factors. It is also characterized by WITH CLEAR AND CLOCK ENABLE. A high level output current of -24mAis set. It is set to 115mAfor the low level output current. Ideally, the operating temperature should be below 85°C. The operating temperature should be higher than -40°C. It operates with the minimal supply voltage of 4.5V. 5.5Vis its maximum supply voltage. BUS DRIVERis the logic IC it uses. There are 2 functions available on this T flip flop. This device is equipped with a pin count of 56.

74FCT162823CTPVG Features

56 pins
18 Bits
5V power supplies
2 Functions
56 pin count

74FCT162823CTPVG Applications

There are a lot of Integrated Device Technology (IDT) 74FCT162823CTPVG Flip Flops applications.

• Data Synchronizers
• Synchronous counter
• ESD performance
• Load Control
• Latch
• Dynamic threshold performance
• Digital electronics systems
• Bounce elimination switch
• Storage registers
• Parallel data storage