74FCT16374CTPAG8

74FCT16374CTPAG8 Overview

It is packaged in the way of TFSOP. The list contains 2 elements. There are 48 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. The power source is powered by 5V. A device of this type belongs to the family of FCT. It is mounted by the way of Surface Mount. This board is designed with 48pins on it. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. It is designed with 16bits. As a result of its reliable performance, this T flip flop is suitable for TAPE AND REEL. It runs on 5Vvolts of power. The D flip flop has no ports embedded. For high efficiency, the supply voltage should be set to 5V. 500μAquiescent current consumed. Furthermore, it has POWER OFF DISABLE O/PS; IOH MAX DURATION < 1S; MAX OUTPUT SKEW = 0.5NSas a characteristic. In this case, the high level output current is set to -32mA. 32mAis set as the low level output current. A temperature below 85°Cis recommended for operation. It should be higher than -40°Cwhen the system is operating. It operates with the minimal supply voltage of 4.5V. It is capable of supporting a maximum supply voltage of 5.5V. BUS DRIVERis the logic IC it uses. The T flip flop is equipped with 2functions . 48pins are provided on the D latch.

74FCT16374CTPAG8 Features

48 pins
16 Bits
5V power supplies
2 Functions
48 pin count

74FCT16374CTPAG8 Applications

There are a lot of Integrated Device Technology (IDT) 74FCT16374CTPAG8 Flip Flops applications.

• Bounce elimination switch
• Balanced Propagation Delays
• 2 – Bit synchronous counter
• Parallel data storage
• Storage Registers
• Memory
• Latch
• Safety Clamp
• Pattern generators
• Automotive