74FCT2374CTSOCTE4

74FCT2374CTSOCTE4 Overview

The package is in the form of 20-SOIC (0.295, 7.50mm Width). As part of the package Tape & Reel (TR), it is embedded. This output is configured with Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. There is an electronic component mounted in the way of Surface Mount. Powered by a 4.75V~5.25Vvolt supply, it operates as follows. The operating temperature is -40°C~85°C TA. This electronic flip flop is of type D-Type. FPGAs belonging to the 74FCTseries contain this type of chip. D latch consists of 1 elements. As a result, it consumes 200μA of quiescent current without being affected by external factors. 20terminations have occurred. The 74FCT2374 family contains it. Power is provided by a 5V supply. Input capacitance of this device is 5pF farads. It is a member of the FCTfamily of D flip flop. There is an electronic part mounted in the way of Surface Mount. This board has 20 pins. There is a clock edge trigger type of Positive Edgeon this device. The RS flip flops belongs to FF/Latches base part number. The maximal supply voltage (Vsup) reaches 5.25V. Normally, the supply voltage (Vsup) should be above 4.75V. Compared to other similar T flip flops, this device offers reliable performance and is well suited for TAPE AND REEL. The system runs on a power supply of 5V watts. This D flip flop is equipped with 0 ports. The 12mA output current allows it to be designed with the greatest amount of flexibility. It operates with 3 output lines. This frequency can be achieved 250MHz.

74FCT2374CTSOCTE4 Features

Tape & Reel (TR) package
74FCT series
20 pins
5V power supplies

74FCT2374CTSOCTE4 Applications

There are a lot of Texas Instruments 74FCT2374CTSOCTE4 Flip Flops applications.

• Common Clocks
• Divide a clock signal by 2 or 4
• Buffer registers
• Balanced Propagation Delays
• Balanced 24 mA output drivers
• Dynamic threshold performance
• High Performance Logic for test systems
• Storage registers
• Single Up Count-Control Line
• CMOS Process