74FCT377CTSOG

74FCT377CTSOG Overview

SOICis the way it is packaged. In total, it contains 1 elements. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. A voltage of 5V provides power to the D latch. An electronic device belonging to the family FCTcan be found here. The electronic part is mounted in the way of Surface Mount. Basically, it is designed with a set of 20 pins. Its clock edge trigger type is Positive Edge. It is included in FF/Latches. It is designed with a number of bits of 8. The D latch operates on 5V volts. The supply voltage should be maintained at 5V for high efficiency. Despite external influences, it consumes 1mAof quiescent current. Additionally, you may refer to the D latch's additional WITH HOLD MODE. It is set to -15mAfor the high level output current. There is no low level output current set at 12mA. Ideally, the operating temperature should be lower than 85°C. Ideally, the operating temperature should be greater than -40°C. Despite its minimal supply voltage of 4.75V, it is capable of operating. It is capable of supporting a maximum supply voltage of 5.25V. It adopts a logic IC of type D FLIP-FLOP. It is equipped with 1 Functions . 20pins are available on this JK flip flop.

74FCT377CTSOG Features

20 pins
8 Bits
5V power supplies
1 Functions
20 pin count

74FCT377CTSOG Applications

There are a lot of Integrated Device Technology (IDT) 74FCT377CTSOG Flip Flops applications.

• Safety Clamp
• Single Down Count-Control Line
• ATE
• Data storage
• Bus hold
• Data transfer
• Reduced system switching noise
• Buffered Clock
• Single Up Count-Control Line
• Differential Individual