74HC174PW,112

74HC174PW,112 Overview

As a result, it is packaged as 16-TSSOP (0.173, 4.40mm Width). As part of the package Tube, it is embedded. As configured, the output uses Non-Inverted. It is configured with the trigger Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. A voltage of 2V~6Vis required for its operation. It is operating at a temperature of -40°C~125°C TA. Logic flip flops of this type are classified as D-Type. This type of FPGA is a part of the 74HC series. This D flip flop should not have a frequency greater than 107MHz. D latch consists of 1 elements. There have been 16 terminations. The 74HC174 family contains this object. An input voltage of 5Vpowers the D latch. The input capacitance of this T flip flop is 3.5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. Electronic devices of this type belong to the HC/UHfamily. Electronic part Surface Mountis mounted in the way. A total of 16pins are provided on this board. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. 6bits are used in its design. Vsup reaches its maximum value at 6V. Normally, the supply voltage (Vsup) should be above 2V. High efficiency requires the supply voltage to be maintained at 5V. This input has 6lines. It consumes 8μA current.

74HC174PW,112 Features

Tube package
74HC series
16 pins
6 Bits

74HC174PW,112 Applications

There are a lot of Nexperia USA Inc. 74HC174PW,112 Flip Flops applications.

• Load Control
• Circuit Design
• Event Detectors
• Buffered Clock
• Single Down Count-Control Line
• 2 – Bit synchronous counter
• High Performance Logic for test systems
• Consumer
• Storage Registers
• Power down protection