74HC175D-Q100J

74HC175D-Q100J Overview

As a result, it is packaged as 16-SOIC (0.154, 3.90mm Width). It is contained within the Tape & Reel (TR)package. As configured, the output uses Differential. This trigger is configured to use Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. A voltage of 2V~6Vis required for its operation. -40°C~125°C TAis the operating temperature. The type of this D latch is D-Type. In this case, it is a type of FPGA belonging to the 74HC series. It should not exceed 89MHzin its output frequency. D latch consists of 1 elements. There is 8μA quiescent consumption. There are 16 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. JK flip flop belongs to 74HC175 family. Power is supplied from a voltage of 5V volts. This T flip flop has a capacitance of 3.5pF farads at the input. HC/UHis the family of this D flip flop. Surface Mount mounts this electronic component. It reaches 6Vwhen the supply voltage is maximal (Vsup). Normally, the supply voltage (Vsup) should be kept above 2V. If high efficiency is to be achieved, the supply voltage should be maintained at 5V.

74HC175D-Q100J Features

Tape & Reel (TR) package
74HC series

74HC175D-Q100J Applications

There are a lot of Nexperia USA Inc. 74HC175D-Q100J Flip Flops applications.

• 2 – Bit synchronous counter
• Supports Live Insertion
• Storage Registers
• Single Down Count-Control Line
• Dynamic threshold performance
• Memory
• Individual Asynchronous Resets
• High Performance Logic for test systems
• Communications
• Bounce elimination switch