74LCX74TTR

74LCX74TTR Overview

It is packaged in the way of 14-TSSOP (0.173, 4.40mm Width). It is contained within the Tape & Reel (TR)package. T flip flop uses Differentialas its output configuration. In the configuration of the trigger, Positive Edgeis used. Surface Mountis occupied by this electronic component. The supply voltage is set to 2V~3.6V. It is operating at a temperature of -40°C~85°C TA. D-Typeis the type of this D latch. In this case, it is a type of FPGA belonging to the 74LCX series. This D flip flop should not have a frequency greater than 150MHz. There is a consumption of 10μAof quiescent energy. There have been 14 terminations. If you search by 74LCX74, you will find similar parts. A voltage of 2.7V is used as the power supply for this D latch. Its input capacitance is 6pF farads. Devices in the LVC/LCX/Zfamily are electronic devices. A part of the electronic system is mounted in the way of Surface Mount. The 14pins are designed into the board. This device's clock edge trigger type is Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. The maximal supply voltage (Vsup) reaches 3.6V. A normal operating voltage (Vsup) should remain above 2V. The superior flexibility is achieved through the use of 2 circuits. Compared to other similar T flip flops, this device offers reliable performance and is well suited for TAPE AND REEL. A total of 3.3V power supplies are needed to run it. To operate, the chip has a total of 1 output lines.

74LCX74TTR Features

Tape & Reel (TR) package
74LCX series
14 pins
3.3V power supplies

74LCX74TTR Applications

There are a lot of STMicroelectronics 74LCX74TTR Flip Flops applications.

• Digital electronics systems
• Data storage
• Storage registers
• Memory
• ATE
• Convert a momentary switch to a toggle switch
• Asynchronous counter
• Matched Rise and Fall
• Dynamic threshold performance
• Circuit Design