74LVT374MTCX

74LVT374MTCX Overview

As a result, it is packaged as 20-TSSOP (0.173, 4.40mm Width). It is included in the package Tape & Reel (TR). Currently, the output is configured to use Tri-State, Non-Inverted. In the configuration of the trigger, Positive Edgeis used. The electronic part is mounted in the way of Surface Mount. A voltage of 2.7V~3.6Vis required for its operation. It is operating at a temperature of -40°C~85°C TA. This electronic flip flop is of type D-Type. In this case, it is a type of FPGA belonging to the 74LVT series. Its output frequency should not exceed 160MHz Hz. In total, it contains 1 elements. During its operation, it consumes 190μA quiescent energy. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. This D latch belongs to the family of 74LVT374. The D flip flop is powered by a voltage of 3.3V . Input capacitance of this device is 3pF farads. It is a member of the LVTfamily of D flip flop. This electronic part is mounted in the way of Surface Mount. There are 20pins on it. In this device, the clock edge trigger type is Positive Edge. An electronic part with 8bits has been designed. As soon as 3.6Vis reached, Vsup reaches its maximum value. A normal operating voltage (Vsup) should remain above 2.7V. The superior flexibility of this product is achieved by using 8 circuits. This flip flop has a total of 2ports. For high efficiency, the supply voltage should be kept at 3.3V.

74LVT374MTCX Features

Tape & Reel (TR) package
74LVT series
20 pins
8 Bits

74LVT374MTCX Applications

There are a lot of ON Semiconductor 74LVT374MTCX Flip Flops applications.

• Reduced system switching noise
• Load Control
• Power down protection
• Digital electronics systems
• Data Synchronizers
• Instrumentation
• ESD performance
• Divide a clock signal by 2 or 4
• Circuit Design
• Latch-up performance