74LVT574WM

74LVT574WM Overview

20-SOIC (0.295, 7.50mm Width)is the packaging method. As part of the package Tube, it is embedded. This output is configured with Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. There is an electronic component mounted in the way of Surface Mount. It operates with a supply voltage of 2.7V~3.6V. Temperature is set to -40°C~85°C TA. The type of this D latch is D-Type. JK flip flop is a part of the 74LVTseries of FPGAs. A frequency of 150MHzshould be the maximum output frequency. A total of 1elements are contained within it. During its operation, it consumes 190μA quiescent energy. The number of terminations is 20. The 74LVT574 family contains this object. A voltage of 3.3V is used to power it. A JK flip flop with a 4pFfarad input capacitance is used here. In this case, the D flip flop belongs to the LVTfamily. This electronic part is mounted in the way of Surface Mount. A total of 20pins are provided on this board. There is a clock edge trigger type of Positive Edgeon this device. This device has the base part number FF/Latches. It is designed with a number of bits of 8. Normally, the supply voltage (Vsup) should be above 2.7V. The superior flexibility of this circuit is achieved by using 8 circuits. As a result of its reliability, this D flip flop is ideally suited for RAIL. The flip flop has 2ports embedded within it. For high efficiency, the supply voltage should be kept at 3.3V. With a current output of 64mA , it offers maximum design flexibility. In order for the chip to function, it has 3output lines. 1 inputs are employed.

74LVT574WM Features

Tube package
74LVT series
20 pins
8 Bits

74LVT574WM Applications

There are a lot of ON Semiconductor 74LVT574WM Flip Flops applications.

• Pattern generators
• Asynchronous counter
• Set-reset capability
• Shift registers
• Modulo – n – counter
• Event Detectors
• Buffer registers
• Counters
• 2 – Bit synchronous counter
• Communications