74LVT574WMX

74LVT574WMX Overview

In the form of 20-SOIC (0.295, 7.50mm Width), it has been packaged. A package named Tape & Reel (TR)includes it. As configured, the output uses Tri-State, Non-Inverted. This trigger is configured to use Positive Edge. It is mounted in the way of Surface Mount. A supply voltage of 2.7V~3.6V is required for operation. Currently, the operating temperature is -40°C~85°C TA. This D latch has the type D-Type. FPGAs belonging to the 74LVTseries contain this type of chip. Its output frequency should not exceed 150MHz. In total, it contains 1 elements. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. This D latch belongs to the family of 74LVT574. An input voltage of 3.3Vpowers the D latch. This JK flip flop has a 4pFfarad input capacitance. In this case, the D flip flop belongs to the LVTfamily. Electronic part Surface Mountis mounted in the way. The 20pins are designed into the board. This device has the clock edge trigger type of Positive Edge. It is included in FF/Latches. The flip flop is designed with 8bits. Normally, the supply voltage (Vsup) should be above 2.7V. Its flexibility is enhanced by 8 circuits. In view of its reliability, this D flip flop is a good fit for TAPE AND REEL. This flip flop has a total of 2ports. A high level of efficiency can be achieved by maintaining the supply voltage at 3.3V. In order for the chip to function, it has 3output lines. It consumes 190μA of quiescent current without being affected by external factors.

74LVT574WMX Features

Tape & Reel (TR) package
74LVT series
20 pins
8 Bits

74LVT574WMX Applications

There are a lot of ON Semiconductor 74LVT574WMX Flip Flops applications.

• Data transfer
• Event Detectors
• Balanced 24 mA output drivers
• Registers
• Pattern generators
• CMOS Process
• Clock pulse
• Consumer
• Synchronous counter
• Buffered Clock