74LVTH273SJ

74LVTH273SJ Overview

20-SOIC (0.209, 5.30mm Width)is the way it is packaged. Package Tubeembeds it. It is configured with Non-Invertedas an output. In the configuration of the trigger, Positive Edgeis used. In this case, the electronic component is mounted in the way of Surface Mount. The JK flip flop operates at a voltage of 2.7V~3.6V. The operating temperature is -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. In FPGA terms, D flip flop is a type of 74LVTHseries FPGA. Its output frequency should not exceed 150MHz. In total, there are 1 elements. T flip flop consumes 190μA quiescent energy. It is a member of the 74LVTH273 family. JK flip flop input capacitance is 3pF farads. There is an electronic component mounted in the way of Surface Mount. This board has 20 pins. A Positive Edgeclock edge trigger is used in this device. There are 8bits in its design. Its superior flexibility is attributed to its use of 8 circuits. The supply voltage should be maintained at 3.3V for high efficiency. There are no output lines on the JK flip flop. Currently, there are 4 input lines present. A -32mAis set for the high level output current. There is 64mA output current at the low level. It is recommended that the operating temperature be below 85°C. Ideally, the operating temperature should be higher than -40°C. The minimum voltage required for operation is 2.7V. In this case, it supports a maximum supply voltage of 3.6V. This can be achieved at a frequency of 150MHz.

74LVTH273SJ Features

Tube package
74LVTH series
20 pins
8 Bits

74LVTH273SJ Applications

There are a lot of ON Semiconductor 74LVTH273SJ Flip Flops applications.

• Differential Individual
• Data Synchronizers
• High Performance Logic for test systems
• Circuit Design
• Functionally equivalent to the MC10/100EL29
• Data transfer
• Computing
• Load Control
• Automotive
• Convert a momentary switch to a toggle switch