74LVTH273WMX

74LVTH273WMX Overview

The item is packaged in 20-SOIC (0.295, 7.50mm Width)cases. The Tape & Reel (TR)package contains it. It is configured with Non-Invertedas an output. It is configured with a trigger that uses a value of Positive Edge. This electronic part is mounted in the way of Surface Mount. A 2.7V~3.6Vsupply voltage is required for it to operate. It is operating at -40°C~85°C TA. It is an electronic flip flop with the type D-Type. In FPGA terms, D flip flop is a type of 74LVTHseries FPGA. You should not exceed 150MHzin the output frequency of the device. In total, it contains 1 elements. Despite external influences, it consumes 190μAof quiescent current. This D latch belongs to the family of 74LVTH273. Its input capacitance is 3pFfarads. The electronic part is mounted in the way of Surface Mount. This board has 20 pins. Its clock edge trigger type is Positive Edge. The design is based on 8bits. Its superior flexibility is attributed to its use of 8 circuits. The supply voltage should be maintained at 3.3V for high efficiency. In order to operate, the chip has 7 output lines. A total of 4input lines have been provided. A -32mAvalue is set for the high level output current. A 64mAvalue is set for low-level output current. There should be a temperature below 85°Cduring operation. Operating temperatures should be above -40°C. The RS flip flop is designed to operate with a minimal supply voltage of 2.7VV. It supports the maximal supply voltage of 3.6V. A frequency of 150MHzcan be achieved.

74LVTH273WMX Features

Tape & Reel (TR) package
74LVTH series
20 pins
8 Bits

74LVTH273WMX Applications

There are a lot of ON Semiconductor 74LVTH273WMX Flip Flops applications.

• Divide a clock signal by 2 or 4
• ESD protection
• Data storage
• Shift registers
• Single Up Count-Control Line
• Asynchronous counter
• Bus hold
• Load Control
• Latch
• Matched Rise and Fall