74LVX174SJ

74LVX174SJ Overview

16-SOIC (0.209, 5.30mm Width)is the way it is packaged. As part of the package Tube, it is embedded. It is configured with Non-Invertedas an output. It is configured with a trigger that uses Positive Edge. Surface Mountmounts this electrical part. A 2V~3.6Vsupply voltage is required for it to operate. Temperature is set to -40°C~85°C TA. This logic flip flop is classified as type D-Type. The 74LVXseries comprises this type of FPGA. Its output frequency should not exceed 95MHz. In total, it contains 1 elements. As a result, it consumes 4μA quiescent current and is not affected by external forces. The 74LVX174 family contains it. Input capacitance of this device is 4pF farads. In this case, the electronic component is mounted in the way of Surface Mount. This board has 16 pins. A Positive Edgeclock edge trigger is used in this device. It is designed with 6bits. Using 7 circuits, it is highly flexible. There are 6 output Lines, which generate the binary equivalent of the input line whose value is equal to “1” and are available to encode either a decimal or hexadecimal input pattern to typically a binary or “B. C. D” (binary coded decimal) output code. The number of input lines is 3. A -4mAvalue is set for the high level output current. There is no low level output current set at 4mA. Ideally, the operating temperature should be lower than 85°C. Ideally, the operating temperature should be greater than -40°C. The minimum voltage required for operation is 2V. There is a maximum voltage support of 3.6V. 180MHzis the maximum frequency that can be achieved.

74LVX174SJ Features

Tube package
74LVX series
16 pins
6 Bits

74LVX174SJ Applications

There are a lot of ON Semiconductor 74LVX174SJ Flip Flops applications.

• Dynamic threshold performance
• 2 – Bit synchronous counter
• Data Synchronizers
• Shift registers
• Single Down Count-Control Line
• Frequency division
• Latch-up performance
• Clock pulse
• ATE
• Counters