74LVX574MTCX

74LVX574MTCX Overview

The package is in the form of 20-TSSOP (0.173, 4.40mm Width). D flip flop is included in the Tape & Reel (TR)package. There is a Tri-State, Non-Invertedoutput configured with it. It is configured with the trigger Positive Edge. It is mounted in the way of Surface Mount. Powered by a 2V~3.6Vvolt supply, it operates as follows. The operating temperature is -40°C~85°C TA. A flip flop of this type is classified as a D-Type. JK flip flop is a part of the 74LVXseries of FPGAs. This D flip flop should not have a frequency greater than 75MHz. The list contains 1 elements. This process consumes 4μA quiescents. You can search similar parts based on 74LVX574. There is 4pF input capacitance for this T flip flop. Electronic part Surface Mountis mounted in the way. It is designed with 20 pins. This device has the clock edge trigger type of Positive Edge. An electronic part with 8bits has been designed. To achieve this superior flexibility, 8 circuits are used. The JK flip flop is with 8 output lines to operate. It has 1lines. There is -4mA output current at the high level. There is no low level output current set at 4mA. Operating temperatures should be lower than 85°C. Operating temperatures should be above -40°C. The minimum voltage required for operation is 2V. In this case, it supports a maximum supply voltage of 3.6V. 125MHzis the maximum frequency that can be achieved.

74LVX574MTCX Features

Tape & Reel (TR) package
74LVX series
20 pins
8 Bits

74LVX574MTCX Applications

There are a lot of ON Semiconductor 74LVX574MTCX Flip Flops applications.

• Memory
• Buffered Clock
• Divide a clock signal by 2 or 4
• Latch
• Control circuits
• Clock pulse
• ATE
• Computers
• Circuit Design
• Synchronous counter