74LVX574SJ

74LVX574SJ Overview

20-SOIC (0.209, 5.30mm Width)is the way it is packaged. The package Tubecontains it. This output is configured with Tri-State, Non-Inverted. It is configured with a trigger that uses Positive Edge. There is an electric part mounted in the way of Surface Mount. A voltage of 2V~3.6Vis used as the supply voltage. In the operating environment, the temperature is -40°C~85°C TA. This logic flip flop is classified as type D-Type. In FPGA terms, D flip flop is a type of 74LVXseries FPGA. You should not exceed 75MHzin its output frequency. There are 1 elements in it. This process consumes 4μA quiescents. Members of the 74LVX574family make up this object. Input capacitance of this device is 4pF farads. A part of the electronic system is mounted in the way of Surface Mount. A total of 20pins are provided on this board. There is a clock edge trigger type of Positive Edgeon this device. This flip flop is designed with 8 Bits. The superior flexibility is achieved through the use of 8 circuits. The JK flip flop is with 8 output lines to operate. It is reported that there are 1 input lines. High level output current is set to -4mA. The low level output current is set to 4mA. The operating temperature should be lower than 85°C. The operating temperature should be higher than -40°C. In order for it to operate, a supply voltage of 2Vis required. There is a maximum supply voltage of 3.6V. This can be achieved at a frequency of 125MHz.

74LVX574SJ Features

Tube package
74LVX series
20 pins
8 Bits

74LVX574SJ Applications

There are a lot of ON Semiconductor 74LVX574SJ Flip Flops applications.

• Balanced Propagation Delays
• Latch
• Convert a momentary switch to a toggle switch
• Set-reset capability
• Data Synchronizers
• Pattern generators
• Shift registers
• Balanced 24 mA output drivers
• Instrumentation
• Clock pulse