74VCX162374MTDX

74VCX162374MTDX Overview

It is packaged in the way of 48-TFSOP (0.240, 6.10mm Width). The package Tape & Reel (TR)contains it. It is configured with Tri-State, Non-Invertedas an output. JK flip flop uses Positive Edgeas the trigger. Surface Mountis occupied by this electronic component. The JK flip flop operates with an input voltage of 1.4V~3.6V volts. A temperature of -40°C~85°C TAis used in the operation. Logic flip flops of this type are classified as D-Type. The 74VCXseries comprises this type of FPGA. There should be no greater frequency than 250MHzon its output. In total, it contains 2 elements. This process consumes 20μA quiescents. Members of the 74VCX162374family make up this object. The input capacitance of this T flip flop is 6pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. It is mounted by the way of Surface Mount. This board is designed with 48pins on it. It has a clock edge trigger type of Positive Edge. There are 16bits in this flip flop. Using 2 circuits, it is highly flexible. In order for the chip to function, it has 16output lines. The number of input lines is 2. A -12mAvalue is set for the high level output current. The low level output current is set to 12mA. A temperature below 85°Cshould be used for operation. Ideally, the operating temperature should be greater than -40°C. In order for it to operate, a supply voltage of 1.4Vis required. There is a maximum supply voltage of 3.6V. The frequency that can be achieved is 250MHz.

74VCX162374MTDX Features

Tape & Reel (TR) package
74VCX series
48 pins
16 Bits

74VCX162374MTDX Applications

There are a lot of ON Semiconductor 74VCX162374MTDX Flip Flops applications.

• Single Down Count-Control Line
• Event Detectors
• Load Control
• Bus hold
• Patented noise
• Modulo – n – counter
• Individual Asynchronous Resets
• Frequency Divider circuits
• Bounce elimination switch
• Automotive