74VHCT374AM

74VHCT374AM Overview

20-SOIC (0.295, 7.50mm Width)is the way it is packaged. A package named Tubeincludes it. There is a Tri-State, Non-Invertedoutput configured with it. In the configuration of the trigger, Positive Edgeis used. Surface Mountmounts this electrical part. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. It is operating at a temperature of -40°C~85°C TA. It is an electronic flip flop with the type D-Type. In FPGA terms, D flip flop is a type of 74VHCTseries FPGA. You should not exceed 130MHzin its output frequency. A total of 1 elements are present. Despite external influences, it consumes 4μAof quiescent current. This D latch belongs to the family of 74VHCT374. A JK flip flop with a 4pFfarad input capacitance is used here. This electronic part is mounted in the way of Surface Mount. With its 20pins, it is designed to work with most electronic flip flops. A Positive Edgeclock edge trigger is used in this device. Due to its superior flexibility, it uses 8 circuits. In order to ensure high efficiency, the supply voltage should remain at 5V.

74VHCT374AM Features

Tube package
74VHCT series
20 pins

74VHCT374AM Applications

There are a lot of ON Semiconductor 74VHCT374AM Flip Flops applications.

• Guaranteed simultaneous switching noise level
• Registers
• Storage registers
• Latch-up performance
• Data transfer
• Circuit Design
• Bus hold
• Modulo – n – counter
• Functionally equivalent to the MC10/100EL29
• Divide a clock signal by 2 or 4