ADP1871ARMZ-1.0-R7

ADP1871ARMZ-1.0-R7 Overview

This switching controller fits most application requirements since it is packaged in a 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) package. It is sufficient to generate 1 outputs with this dc motor controller. There is a Tape & Reel (TR) solid enclosure around the pmic. With this function, you can deal with Transistor Driver dc switching's outputs (s). The supply and operating voltage of the dc control are 3.25V~20V. Suitable for a -40°C~125°C TJ dc switcher. Using this switching controller, it is possible to switch at 1MHz. dc dc regulator can be generalized using Surface Mount. For efficient switching control, the dcdc regulator features Enable. The switch converters are connected to an analog IC with a SWITCHING CONTROLLER output. switching converters terminal (s) are designed to be at DUAL. A variety of terminations with 10 of dc switching. PULSE WIDTH MODULATION is an example of one of the control techniques these dc dc converter ics adapt. DC switcher's input voltageis 12V volts. Other relevant dc to dc converter ics can be found by searching "ADP1871". 10 pins are on switching converter. The type is a particular Switching Regulator or Controllers of switching converter. Test statistics indicate DC regulator outputs 600mV voltage. You should note down the dc dc regulator's usual output current of 25A when you start a project. During power-up and power-down, the maximum duty cycle of the voltage regulator dc to dc is set to 45 %. The Surface Mount makes DC switcher suitable for most applications and prototypes. This value is MINIMUM OUTPUT VOLTAGE: 0.6V so that DC to DC voltage regulator better serves the purpose. In order to run the voltage regulator dc to dc safely and reliably, users are advised to apply 20V. Since the dc switcher's maximum input voltage is 20V, the voltage must be regulated accordingly. Voltage 2.95V must be supplied. DC switchers cannot produce output currents greater than 25A. Datasheets state the switching converter can output up to 18V volts. A supply current of 140μA is used to power it. At least 600mV voltage is output by the voltage controller. The nominal supply current for this the controllers dc is 1.1mA.

ADP1871ARMZ-1.0-R7 Features

Transistor Driver Outputs
Switching Frequency: 1MHz
Enable
PULSE WIDTH MODULATION
Max Duty Cycle: 45 %
MINIMUM OUTPUT VOLTAGE: 0.6V

ADP1871ARMZ-1.0-R7 Applications

There are a lot of Analog Devices Inc. ADP1871ARMZ-1.0-R7 DC to DC converter applications.

• Product burn-in
• Servo drive system
• Computed tomography (CT)
• Experimental setup
• Printing equipment
• Photovoltaic power
• Automation technology
• Drilling machines
• Thermal power
• Digital precision reference circuits