CD4013BPWR

CD4013BPWR Overview

The package is in the form of 14-TSSOP (0.173, 4.40mm Width). The Cut Tape (CT)package contains it. In the configuration, Differentialis used as the output. The trigger configured with it uses Positive Edge. There is an electronic component mounted in the way of Surface Mount. The supply voltage is set to 3V~18V. In this case, the operating temperature is -55°C~125°C TA. This electronic flip flop is of type D-Type. JK flip flop is a part of the 4000Bseries of FPGAs. There should be no greater frequency than 24MHzon its output. During its operation, it consumes 4μA quiescent energy. There are 14 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. It is a member of the CD4013 family. It is powered by a voltage of 5V . This JK flip flop has a 5pFfarad input capacitance. Surface Mount mounts this electronic component. This board is designed with 14pins on it. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. There is a base part number FF/Latchfor the RS flip flops. Normal operation requires a supply voltage (Vsup) above 3V. In order to achieve its superior flexibility, 2 circuits are used. On the basis of its reliable performance, this D flip flop is well suited for use with TR. This T flip flop features a maximum design flexibility due to its output current of 6.8mA. There are no output lines on the JK flip flop. 20μAquiescent current consumed.

CD4013BPWR Features

Cut Tape (CT) package
4000B series
14 pins

CD4013BPWR Applications

There are a lot of Texas Instruments CD4013BPWR Flip Flops applications.

• QML qualified product
• Consumer
• Buffered Clock
• Guaranteed simultaneous switching noise level
• Counters
• Shift registers
• Automotive
• Latch-up performance
• Individual Asynchronous Resets
• Patented noise