CD74ACT112MG4

CD74ACT112MG4 Overview

The flip flop is packaged in SOIC. A total of 2elements are contained within it. 16terminations have occurred. Power is supplied from a voltage of 5V volts. Electronic devices of this type belong to the ACTfamily. This electronic part is mounted in the way of Surface Mount. 16pins are included in its design. There is a clock edge trigger type of Negative Edgeon this device. There is a FF/Latchesbase part number assigned to the RS flip flops. The flip flop is designed with 2bits. Due to its reliability, this T flip flop is well suited for TUBE. An electrical current of 5V volts is applied to it. Optimal efficiency requires a supply voltage of 5V. There are 1 output Lines, which generate the binary equivalent of the input line whose value is equal to “1” and are available to encode either a decimal or hexadecimal input pattern to typically a binary or “B. C. D” (binary coded decimal) output code. Quiescent current is consumed by the D latch in the amount of 4μA. A -24mAis set for the high level output current. It is set to 24mAfor the low level output current. Operating temperatures should be lower than 125°C. It is recommended that the operating temperature be greater than -55°C. It operates with the minimal supply voltage of 4.5V. 5.5Vis the maximum supply voltage it supports. It is possible to achieve 100MHz frequencies. The logic IC it uses is J-K FLIP-FLOP. There are 2 functions available on the JK flip flop. There are 16 pins on the D latch. It offers maximum design flexibility with its output current of 24mA.

CD74ACT112MG4 Features

16 pins
2 Bits
5V power supplies
2 Functions
16 pin count

CD74ACT112MG4 Applications

There are a lot of Texas Instruments CD74ACT112MG4 Flip Flops applications.

• Counters
• Buffered Clock
• Memory
• Dynamic threshold performance
• ESD performance
• Data storage
• Divide a clock signal by 2 or 4
• Data Synchronizers
• Reduced system switching noise
• Convert a momentary switch to a toggle switch